Hello everyone,
I have one project which I’m developing in Xojo 2017r3. Until yesterday, it was working normally, but after XOJO became slow and all actions were delayed, I restarted PC, and cleared cache from %APPDATA% and %TEMP%.
After that, I tried loading this project, and XOJO hangs totally. In most times, it is not responding for few minutes, and after that, something wrong happens and it affects entire machine, my screen and other applications start flickering. At the same point, loading progress bar becomes Indeterminate.
Trying to figure out what is happening, I found out that problem could be in file for Main Window. It is in xojo_xml_code, and entire window is 3.65 MB. There is no any syntax error in this xml, and I tried loading project using these versions: 2017r3, 2018r3, 2021r3, 2023r2, 2025r1, with very similar outcome.
Main window has 387 controls, and if I remove all of them, I can load project. After that, I tried with 50 controls, and each time, it loaded. Event if I remove any 10+ controls, project will be loaded.
I was wondering, what could I do next to load full project? Is there a limit in number of controls on single Window?
Tried loading project on 2 machines, same happens on both of them.
I have one project, where Main Window has 508 controls, but file is smaller for 30KB than this one, and that project normally loads.
6 posts - 3 participants